The mark on the pump "usually" lines up w/ "O" degrees on the engine block.Section Ca. Then there is a set of degree marks stamped into the engine block & a timing line on the inj. There is a "pin" in the drive gear & 3 bolts that hold it on.
Two injection pump timing marks areThe CAV pump is master splined on the drive. To correct the timing on the Bosch® P-7100 and Nippondenso EP-9, see the replacement procedure for the respective pump. However, for troubleshooting and in an emergency, visual alignment of the timing mark is close enough for the engine to run. Stanadyne DB2 and DB4 Model Injection Pump Stanadyne Retained Drive Shaft Removal and Installation Instructionsthe Lucas CAV DPA fuel injection pump precisely.
There should be a line on mounting flange of pump and another on back side of timing cover that line up with each other, there is a little dowel pin in gear so you can’t get timing 180 off Little Red Members 422 Gender:Male Location:South Dakota Posted February 13 your lines should be here mike newman Members 6.7k On these injection pumps, the drive shaft stays in the engine and the injection pump to engine timing is usually “cam timed” to set the pump to engine timing. Hopefully this info helps so.Lucas CAV DPA Fuel Injection Pumps Basket is empty Categories Lister Diesel Engine Spares Lister Petrol Engine Spares Petter Diesel Engine Spares Petter Petrol Engine Spares Wolseley Engine Spares (32) Ruston Hornsby Spares (28) Clearance Corner (6) Genuine Lister Parts stock Peter Slater Fuel Injection Engineers Data Archive Reviews Special Briefly discussing the 2:1 gear ratio that drives the CAV DPA distributor type injector pump on a Perkins 4.203.2 Diesel engine. If you move it far off of zero, it will be a PITA to start. There are markings on the front mounting flange of the pump. Your 555 has a CAV injection pump, which is normally set at zero degrees. The number 1 cylinder is the front cylinder. Howdy Killercown, Welcome to the tractor forum. 
The fuel pump hub is fitted to the shaft in the. Illustration (C) shows the nut in position when the fuel pump is fitted to the engine. Lucas DP 200 Series fuel injection pump To remove to fit 20-10 Special tools: Timing pin PD.246, Lucas fuel injection pumps General description Caution:Do not release the nut (C2) from the fuel injection pump.
0 kommentar(er)
